Why Does My Iron Keep Tripping the Electrics?

Author Fred Montelatici

Posted Nov 17, 2022

Reads 71

Circuit board close-up

There are a few reasons why your iron might keep tripping the electrics. The first possibility is that the iron is faulty and is not properly grounded. If this is the case, you should replace the iron. Another possibility is that the electrical outlet is not properly grounded. If this is the case, you should have an electrician look at the outlet. Finally, it is also possible that the circuit breaker is tripping because the electrical circuit is overloaded. If this is the case, you should have an electrician look at the circuit to see if it is safe to add more electrical devices to it.

Frequently Asked Questions

Why is my Iron tripping?

An accumulation of lint, fluff, and other debris can build up inside an iron and cause it to trip. This cycling can continue until either the iron shorts out or the RCD (rear-circuit controller) fails.

Why is my Iron not working?

There could be other faults. You could try opening up the area where the wires enter (unplug the iron first of course), use a tissue to dry up any obvious wetness and leave it to dry in a warm place for a day or two and then see if it works without tripping the RCD. Check that the wiring is all secure and correct too. Or you could buy a new iron.

Why are my Home’s electrics tripping?

A typical home will have a circuit breaker fuse system, located near the electricity meter or at the entrance. This is in case of an electrical fault, thereby tripping the switch and breaking the circuit.

Why does my Iron keep breaking the cable?

This could be due to a number of factors such as the lead being pushed against a nearby surface, or if the ironing board is in an awkward position. If this is happening regularly, it might be worth considering having the socket checked to see if there's anything blocking its movement.

Why does my Iron keep tripping when filling with water?

If the customer’s iron is constantly tripping when filling with water, it may be due to something more serious than just a broken switch. In this case, an electrician should be called in to investigate the cause.

Fred Montelatici

Fred Montelatici

Writer at Go2Share

View Fred's Profile

Fred Montelatici is a seasoned writer with a passion for digital marketing. He has honed his skills over the years, specializing in content creation and SEO optimization. Fred's ability to craft compelling narratives and translate complex topics into digestible articles has earned him recognition within the industry.

View Fred's Profile